Magicard 300 / 600 Calibration routine

Modified on Fri, 23 Sep 2022 at 10:40 AM

Magicard 600

  1. Open the lid.
  2. Remove the dye film.
  3. Close the lid.
  4. Once the printer initialises (no film inside!).
  5. Press Menu.
  6. Press and hold the middle two buttons for at least 5 seconds (maintenance menu).
  7. Scroll down to Calibrate. Select this item.
  8. Confirm there is no film fitted by pressing Next.
  9. The display will show CALIBRATING . . . for a few seconds.
  10. When complete (returns to maintenance menu), press the Left button to exit maintenance mode.
  11. Open the lid, refit the colour dye film, close the lid.
  12. The printer should now be ready to print normally again.



Magicard 300


  1. Open the lid.
  2. Remove the dye film.
  3. Once the printer initialises (no film inside!).
  4. Press and hold Menu until LCD "Clean Rollers" Changes to say "Turn Rollers".
  5. Click Next
  6. Menu will display Calibrate. Select OK
  7. Close lid when prompted
  8. The display will show CALIBRATING . . . for a few seconds.
  9. When complete (returns to maintenance menu), press the Left button to exit maintenance mode.
  10. Open the lid, refit the colour dye film, close the lid.
  11. The printer should now be ready to print normally again.

Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select atleast one of the reasons
CAPTCHA verification is required.

Feedback sent

We appreciate your effort and will try to fix the article