Magicard 300 soak test

Modified on Wed, 05 Apr 2023 at 04:24 PM

Open the lid.

Press and hold Menu button (for at least 5 seconds)

(the display will change from Clean Rollers to Turn Rollers).

This is the maintenance menu.

Press Next to get to SOAK Printer press OK.

Confirm the dye film is removed.

It will prompt that the lid is open (close the lid).

Resume choosing SOAK TEST -> SOAK PRINTER -> Dye film is removed -> Next

The display will say Calibrating for a few seconds.

It will then require you to feed 1x card in.

The soak test needs to run a minimum of 10 cycles (you can press Cancel on the 11th).


Or you can let it run, till the whole bar is completed it will then eject the card out successfully?

Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select atleast one of the reasons
CAPTCHA verification is required.

Feedback sent

We appreciate your effort and will try to fix the article